The Munich–Venice Cycle Route crosses Germany, Austria and Italy over approximately 560 km. It links Bavaria and Tyrol with the Dolomites and the Adriatic, combining established cycle routes with smaller roads.
Cities, lakes and Alpine valleys
Munich, Innsbruck and Venice anchor the journey, with towns including Bad Tölz, Schwaz, Brixen and Treviso along the wider route. Existing routes such as the Inn cycleway form part of the connection.
Scenic highlights include Tegernsee, Sylvensteinspeicher, Achensee, the Isar, the Tyrolean Wipptal, Cadore and Lago di Santa Croce. The Dolomites provide a major mountain setting before the approach to the Adriatic.
Riding conditions
The organiser explicitly describes a cycle route with some mixed traffic on side roads. Riders should expect sections shared with motor vehicles as well as dedicated cycling infrastructure.
Planning and current notices
The website provides a route map, GPS downloads, accommodation, bicycle services and shuttle or return-transport information. Bus and rail links support travelling shorter sections.
Check the announcements before departure. The portal lists an alternative recommendation between St. Jodok and Brenner and intermittent Piave cycleway closures near Castellavazzo and Longarone because of roadworks.
The official Munich start and the five regions
The official start is at Zenneck Bridge behind the Deutsches Museum in Munich. Marienplatz is a pedestrian-only area and is not the route’s starting point. For the reverse journey, the same bridge marks the Munich finish.
The organizer groups the crossing into five landscape and cultural areas: Bavaria’s water landscapes, Tyrol’s mining and valley towns, the Alpine–Mediterranean setting south of Brenner, the Dolomites and the Venetian plain. Its published overview gives around 5,000 m of ascent. The final plain contrasts with the mountain crossings, so daily stage profiles matter when deciding where to shorten the trip.